Re: [LCtalk] Help! Can't Connect to Lanbox, No idea what is supposed to happen on reset

[Matthijs van Duin]

On Sun, Oct 14, 2007 at 12:01:42PM -0400, Kevin Cole wrote:
> As a last attempt I reset my lanbox by opening it up and pressing the 
> reset button for 10 seconds on power up. The display said "ABRT" then 
> flashed, then said and stopped at "BOOT". Is this normal for reset?

That procedure *completely* erases the lanbox, including its firmware, 
which you will need to upload again (v2.09 is the current version).

You should be able to connect using LCedit+ (though only firmware upload 
will work), but note that:

An LCX in this state only accepts connections via USB, not via network.

An LCE will be reset to IP address 192.168.1.77.

Hope this helps,

--
Matthijs van Duin  --  May the Forth be with you!