Re: [LCtalk] Fwd: Clear Cue

[Fokko van Duin]

At 13:26 -0500 06-08-2007, Kyle Olson wrote:
> Hello Lanbox List,
>
> I am trying to create a cue that will clear a Lanbox LCE with Layers 
> A - I.  I have created the following cue, however, the cue only 
> works when running it twice.  The first time it freezes all layers 
> in their current state but shows an output of 0.0 on all layers. All 
> channels are disconnected from the layers but still at their last 
> value. Is there a better way to create a "Kill all" cue?

No, not really, but I think it should be:

// Cuelist 9 (11 steps), stored 8/6/2007 1:15 PM
  show d01 for 0.75s
  go 0.0 in layer C
  go 0.0 in layer D
  go 0.0 in layer E
  go 0.0 in layer F
  go 0.0 in layer G
  go 0.0 in layer H
  go 0.0 in layer I
  go 0.0 in layer B
  show d02 for ever

:d01
    1[000]    2[000]    3[000]    4[000]    5[000]    6[255]
 Cue Truncated 1-512 at [000]


:d02
    6[255]


The difference is that all layers get the time to become 0, before 
you clear all but channel 6.

Note: be careful with cues using all 512 channels, the limit of 
active channels on a LCE is 1024 (total of all active channels on all 
layers)!


--
Fokko van Duin,
CDS advanced technology bv,
http://www.lanbox.com/