Re: [LCtalk] Clearing edit enabled, error on lanbox

[Fokko van Duin]

At 13:58 +0200 13-05-2007, Matthias Glastra wrote:
> Dear Fokko,
>
> I was trying too send the following command to the Lanbox.
>
> *CC01000000#
>
> If I am write this will set engine 1 to clear all enabled edit 
> channels. In the manual it says that it is *CC010000# but if I 
> understand the 16bit mode correctly on a LCX it will be 0000. When I 
> send this the command too the demo.lanbox.com it shuts down. At 
> least it looks like that. Do you know why.

The *CC01000000# is correct for 16 bit. The reference states that cc 
becomes cccc in 16 bit mode, so you did it ok, if..... After a new 
connection you you should send out *65FF# (LCedit+ and LCedit for 
PDAs are doing that).


> I tried after a few minutes but now I get denied by demo.lanbox.com. 
> It say's actively denied by target computer.

Yeh, demo.lanbox.com is crashed by someone, but I don't know how it's 
done. I can't even get it restarted via USB, so it's down until 
Monday.

Try cds.xs4all.nl as it's here at home.

--
Fokko van Duin,
CDS advanced technology bv,
http://www.lanbox.com/