[LCtalk] Clearing edit enabled, error on lanbox

[Matthias Glastra]

Dear Fokko,

I was trying too send the following command to the Lanbox.

*CC01000000#

If I am write this will set engine 1 to clear all enabled edit channels. 
In the manual it says that it is *CC010000# but if I understand the 
16bit mode correctly on a LCX it will be 0000. When I send this the 
command too the demo.lanbox.com it shuts down. At least it looks like 
that. Do you know why.

I tried after a few minutes but now I get denied by demo.lanbox.com. It 
say's actively denied by target computer.

Regard,

Matthias