| Subject: | Re: [LCtalk] Trying to automate patching of channels? |
| From: | Fokko van Duin |
| Date: | Tue, 09 May 2006 12:15:02 +0300 |
Is there no way to use the "raw command" option to implement this?
Well if you record a macro, it's sending out raw commands. I made it
for dynamically switching curves on certain pan/tilt channels (made
sine&cosine curves to convert a linear sweep into a circle ;)
I also noticed that between the update I send through ZOC, which
becomes active immediately, I do not see these changes for a while
in my LC-Edit under the Tools - Patch Editor. What is the update
frequency here?
Lowest priority, so it can take a few seconds.
Fokko van Duin,
CDS advanced technology bv,
http://www.lanbox.com/
|
