Re: [LCtalk] Channel gain Fluke, Feature or my fault

[Fokko van Duin]

At 23:43 +0100 23-02-2005, Dennis Peeters wrote:
> My question: Is there a key command or something quick to change the 
> gain to 0%, it's the only thing I can imagine accidently doing. Or 
> is it a bug ?

The fastest way to set some channels to a gain of 0, is by typing 0 
<enter> in the Master Intensity field, e.g. instead of Intensity.

Tip: Check the master Intensity that the field is never blank, but 
shows 100% whenever you have selected fixtures.

Tip2: Do not set the Master Intensity above 100%, as due to a 
firmware issue you can get funny results if the calculated DMX value 
of a light channel ends above 255. It's fixed in firmware 2.04

--
Fokko van Duin,                     Creators of the LanBox-LC
CDS advanced technology bv,         DMX lighting controller.
http://www.cds.nl/                  http://www.lanbox.com/

We are member of MIDI Manufacturers Association, MMA