[LCtalk] Patch: 2 cue channels to 1 DMX channel?

[Jorg Schellekens]

Hello,

A quick question which popped up two days ago:
Is it possible to patch 2 channels to 1 DMX adress?
For example both LcEdit channel 1 and 2 go to DMX channel 1?

This might seem a bit of a weird thing to do, but i ran into it when i had 
to downscale a touring show for a specific venue which had too little 
dimmers. I had an already programmed show which normally uses 52 dimmers & 
dimmer channels, which i had to adapt to a 24 dimmer venue. For a few 
dimmers the best solution was to connect some fixtures which are usually on 
separate dimmers to 1 dimmer. However in the cues i then needed both of the 
channels to send data to one DMX channel. Couldn't figure it out on the spot 
so i used the cuelist editor to quickly copy some channel values. However 
i'd still like to know if it can be done?

Regards,

Jorg Schellekens