Forums
| LanBox Products :: Forums :: Hardware :: LanBox LCX |
|
<< Previous thread | Next thread >> |
| LCE does not connect | ||
|
Moderators: Menno, Wouter, Eric, Matthijs
|
| Author | Post | ||
| Rust627 |
| ||
 Registered Member #210 Joined: Mon Jun 04 2012, 09:23PMPosts: 2 | I am trying to use an LCE but whenever I try to connect it gives me the 'unable to establish connection TCP/IP (192.168.1.77)connection to "untitled interface" '. I have tried pinging the box and i get the correct result. Ive tried crossover cables and normal cat 5 cables, after a week of trying everything in the manual ( and all the suggestions of my friends) I am getting a little frustrated. Can anyone give me any new suggestions as to what may be wrong ( I am sure it is something small and simple) My Macs network settings are manual , 192.168.1.10 , 255.255.255.0 and router is blank. | ||
| Back to top | | ||
| Eric |
| ||
  Registered Member #4 Joined: Tue Nov 01 2011, 04:41AMPosts: 48 | Hi, Ok, probably the LCE does not have the 192.168.1.77 address. Below is the ten step action how to reset your LCE back to the factory defaults. (Both LCE and LCM). 1 Connect the LCE via Ethernet to your computer, The Lanbox is off (not connected to power), 2 Open the top lid of the LCE / LCM by removing the four top screws, 3 Press the small switch inside next to the big light grey connector, 4 While pressing the switch plug in the power adapter, 5 Keep the switch pressed until the message "Abrt" starts to blink rapidly after about 10 seconds, 6 Once the message starts to blink, release the switch and unplug the power adapter, 7 Plug in the power adapter again. The display will state "boot", 8 In LCEdit, connect to the LanBox via the IP address 192.168.1.77, 9 It will connect, no password is asked, and nothing happens because the firmware is erased (you will not see any layers for example), 10 Upload the latest firmware for LCE (v3.01) using the menu bar "tools" -> "upload firmware". The LanBox will ask for the default password twice (777). Thats it. Let me know if that works [ Edited Sat Jun 09 2012, 03:59AM ] | ||
| Back to top | | ||
| Rust627 |
| ||
| Registered Member #210 Joined: Mon Jun 04 2012, 09:23PMPosts: 2 | it worked !! Thank you very much. | ||
| Back to top | | ||
Latest Forum Posts
Posted by wortoltjeI've read somewhere that the lanbox has an DMX merger, but i can'...
24 May : 16:56
Posted by wortoltjeSo, is it possible to use the lanboc (LCX) in combination with a ...
24 May : 15:10
Shopping Cart
|